Active TopicsActive Topics  Display List of Forum MembersMemberlist  Search The ForumSearch  HelpHelp
  RegisterRegister  LoginLogin  

Home | Load data | Articles | Ballistic Calc | Energy Calc
Long Guns
 Handloads.Com Forum : Long Guns
Subject Topic: Trail Boss problems with 223 Post ReplyPost New Topic
Author
Message << Prev Topic | Next Topic >>
dahlin
Senior Member


Avatar

Joined: January 26 2015
Location: Ogema, WI
Posts: 210
Online Status: Offline
Posted: December 29 2018 at 9:42am | IP Logged Quote dahlin

Think it was made for cowboy action shooting. Hornady did not have a listing for 44 special or 44 mag you may be able to find a recipe if you search around a bit. Randy
Back to Top View dahlin's Profile Search for other posts by dahlin
 
RT58
Senior Member




Joined: August 04 2009
Location: NE Ohio
Posts: 671
Online Status: Offline
Posted: December 29 2018 at 11:49am | IP Logged Quote RT58

http://www.adi-powders.com.au/single-action-pistol/

Try starting here. Agree then click on the caliber you want data for.

Edited by RT58 on December 29 2018 at 11:52am
Back to Top View RT58's Profile Search for other posts by RT58
 
Desert Eagle41
Senior Member


Avatar

Joined: January 06 2010
Location: Buuckeye Lake, Ohio
Posts: 1796
Online Status: Offline
Posted: December 29 2018 at 3:17pm | IP Logged Quote Desert Eagle41

RT58, Thanks good data although not the weight bullet I am looking to load but I have loaded some at close to those weights. We will see how it goes maybe tomorrow. Craig

__________________
Wall Street reports today on brisk trading 380 brass finished higher for the last 14 straight months against the euro, dollar and yen.
Back to Top View Desert Eagle41's Profile Search for other posts by Desert Eagle41
 
Buffalogun
Senior Member


Avatar

Joined: April 27 2005
Location: Florida
Posts: 3444
Online Status: Offline
Posted: January 04 2019 at 3:44pm | IP Logged Quote Buffalogun

This may be an appropriate place to mention that the
AR15 and likely most gas operated firearms are cycled
according to dwell time which is the distance from the
gas port to the muzzle.

There must be enough pressure between the gas port and
the muzzle in order to cycle the action properly.
Changing the powder or powder charge weight will vary
the peak pressure, the pressure curve and also the
remaining pressure available to cycle the action
without causing the cycle to be too violent.

Hodgdon recommends H4895 as the powder to use for
reduced loads. Their formula is down to 60% of a full
power load for cartridges that use H4895 as a regular
powder.

I think I'd look into using H4895.



Mike

__________________
"Please Mr. Custer.......I don't want to go" Larry Verne
Back to Top View Buffalogun's Profile Search for other posts by Buffalogun
 

Home | Load data | Articles | Ballistic Calc | Energy Calc

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

<< Prev Page of 2
  Post ReplyPost New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You can vote in polls in this forum

Powered by Web Wiz Forums version
Copyright ©2001-2008 Web Wiz Guide

This page was generated in 0.1250 seconds.